|
Reviews
|
Views
|
|
3
|
222066
|
|
Recommended By
|
Average Price
|
Average Rating
|
|
100% of reviewers
|
None indicated
|
9.0
|
|
|
|
|
|
|
|
Description:
|
Spools & Mini Spools
For racing, serious off-road, or crazy hot-rodders, a spool is the ultimate traction differential. Actually, it can hardly be called a differential because it does not differentiate. Spools have several purposes. First, they lock both left and right axles solid together so that there can be no loss of power due one wheel spinning faster than the other. Second, they usually support the ring gear much better than most other differentials. Last, they can be lighter than a differential, which saves rotating mass as well as un-sprung weight that the suspension has to contain.
The main shortcoming of spools is the fact that the outside wheel has to turn faster when negotiating a turn if both wheels are to maintain traction. If the axles are locked together, one or both wheels have to slip in order for the outside wheel to travel farther than the inside wheel. This can cause the rear of the vehicle to spin out, fish-tale, or can cause a lot of noise that sounds like positraction clutch chatter as the axles twist and release. Sometimes these effects are not all that bad, and they are less severe when 35-spline or larger axles are used. For those people on a budget, there are mini-spools available for many rearend designs.
A mini-spool fits inside the standard open carrier, replacing the spider gears, and locking the left and right axle shafts together just like a spool does. A mini spool drives exactly like a full spool does, but they are not as strong as a full spool and do not add any extra support to the ring gear like a spool does.
|
|
Keywords:
|
Spools Mini Spool Locker Differential Axle Traction
|
|
|
|
|
Anonymous
|
|
Review Date: Sat February 4, 2012
|
Would you recommend the product? Yes |
Price you paid (per item)?: None indicated
| Rating: 10
|
|
Pros:
|
Cheap and easy to install.
|
|
Cons:
|
|
|
I have a mini spool in the rear of my 8.8" ford 1/2 ton. I thought it worked great, with no problems so far for 3 years running 35" boggers.
|
|
|
Anonymous
|
|
Review Date: Sat May 5, 2012
|
Would you recommend the product? Yes |
Price you paid (per item)?: None indicated
| Rating: 0
|
|
Pros:
|
unsurpassed traction off road
|
|
Cons:
|
heavy loads on pavement = broke axles or lug studs
|
|
I have a spool front and rear of my k10,
10 bolt 3/4 ton front, and 14bolt 1ton rear, off road by george ittle go, but with a load of firewood or the car trailer loaded its hard on the rear axle. if you don't have locking hubs or plan on hauling heavy loads on a 1/2 ton axle than a spool is not for you
|
|
|
Anonymous
|
|
Review Date: Sat May 5, 2012
|
Would you recommend the product? Yes |
Price you paid (per item)?: None indicated
| Rating: 8
|
|
a spool in the front creates what is known as torque steer which means its hard to steer for the same reasons that the rear has problems but with locking hubs you can drive on the road with no problem and and just lock one hub for trail riding and both in good mud. its hard to rate this product b cause its the best at what its made for but terrable at everything else
|
|
|
|
|
LoMax for the Dana 300
Editor
|
|
|
;)
;)
;)
;)
;)
