|
Chad's 1968 Scout 800
posted by Editor
My Scout is a 1968 Scout 800 that my dad purchased
in the late 70's. Like 1976 or something. At
that time it had some rust and only one gas tank.
He purchased it for $500. ...
|
764850
|
None
|
3 reviews
|
|
M151A2-LC M151-LC Mutt Prototype - Bleddyn, Micki, and Nate Cynfyn
posted by Editor
Here are several pictures of our 1962 Ford M151-LC
prototype (Desert Racer). The M151 did not have
Rops (Roll bars) our does! The M151 had flat
fenders our were torn so we w ...
|
936955
|
3.00
|
3 reviews
|
|
Jack's 1947 CJ2A Willys
posted by Editor
This is a very nice Willy's Jeep. The vin tag says
that the jeep is a 1947 CJ2A, but according to
some of the features on the vehicle I believe it
is a military M38. The winds ...
|
1074605
|
6.50
|
8 reviews
|
|
Scott's 1985 Toyota 4-Runner
posted by Editor
*1985 Toyota 4-Runner body, length bobbed about 2
feet
*Vortec 350 V8, 4L80e transmission, steering
column and electronics are out of a 1997 3/4-ton
Chevy Suburban.
*Atlas ...
|
1087447
|
7.50
|
2 reviews
|
|
Clay Martin's 1991 Jeep XJ
posted by Editor
Rebuilt 4.0
Rebuilt aw4
Twin electric fans
231 with slip yoke eliminater
cv shafts front and rear
8.8 rear with disks
hp 30 front 4.56's
Lockers in both
6 inch rustie ...
|
1151013
|
6.00
|
3 reviews
|
|
Peter Bonenfant's Thing
posted by Editor
I built this buggy using a Dana 44 front and 12
bolt GM rear full size Chevy axles which I
narrowed 21 inches, welded the spider & side gears
to lock them up then shaved the h ...
|
1198210
|
2.20
|
8 reviews
|
|
Klune V Extreme Underdrive
posted by Editor
Klune-V 4-to-1 Under-Drives Now Available With
Ford 31-spline Input
Klune-V has announced that it's 4-to-1 "David"
under-drive gear box can now be had with built-in
Ford 31 ...
|
225849
|
1.00
|
12 reviews
|
|
OX Trax Locker
posted by Editor
High-Tech aerospace engineering with no castings
or stamped steel components. The OX uses a single
air-craft quality cable to engage from an open
differential to a fully locke ...
|
277556
|
2.14
|
59 reviews
|
|
Tera Low 20 for the Dana 20
posted by Editor
Tera Low20 for Manual Transmissions
The Low20 for manual transmissions kit uses a
six-spline input gear for Dana 20s with MANUAL
transmissions. The kit converts the stock 2 ...
|
267725
|
6.50
|
5 reviews
|